Monday

Shape setting:

After cutting the jig, place tube in curvature, (move small part of jig up, bending tube tube as you go), then place the screws in the small part of the jig, want the tube as snug as possible in the jig. If the tube is thin, but another wire or tube inside to help give it support as it is wedged into the jig. MAKE SURE TO REMOVE THIS BEFORE SETTING.

Tie two large (stripped near connection obviously) wires on both sides (4 total), use lots of solder to attach to the nitinol tube.
Hook up power to the outside of the two, signal on the inside.